Luminance Consulting

Book a meeting
English,

Audit, renovation and profitability

Financing a lighting renovation after the end of incentives

CEE sheets withdrawn in 2026, RES-EC-104 for outdoor lighting, financial leasing, EPC: the levers still available to finance a renovation.

Luminance ConsultingProfessional lighting design office

5 min read

Workshop with overhead crane and walkway, lit by LED luminaires

In January, a maintenance manager reopens a renovation estimate prepared the previous autumn. The amount to be financed appears net of an incentive deducted at the bottom of the page, and that line no longer exists. The budget to be presented to the investment committee therefore changes in nature before the first luminaire has even been chosen.

What the order of 23 February 2026 withdrew

The order of 23 February 2026 removed from the energy savings certificates (CEE) catalogue the three standardised sheets that covered the replacement of indoor luminaires: BAR-EQ-110 for residential, BAT-EQ-127 for commercial buildings and IND-BA-116 for industry. Relamping offices, a workshop or a warehouse therefore no longer has any standardised operation sheet.

The specific operations route remains in the scheme, but it requires an engineering file, an independently reviewed savings calculation and a lengthy assessment. It remains out of reach for most lighting renovation projects. What was withdrawn and what remains is covered in detail in our update on what remains of CEE lighting incentives in 2026.

The practical consequence is immediate. Any quote still showing an incentive deduction for indoor lighting must be reworked, line by line, before being put forward for a decision. A budget approved on a net amount that no longer has any basis will end up overrunning at the time of ordering.

Outdoor lighting: the RES-EC-104 sheet still in force

Outdoor lighting has not met the same fate. The RES-EC-104 sheet, which covers the renovation of outdoor lighting installations, is still in the catalogue. It targets road lighting points, public spaces and site surroundings, with technical conditions of its own that change as revision orders are issued.

For a client who has both buildings and outdoor areas, this changes the order of the works. An ageing stock of lighting columns can become the first phase of the programme, before the halls and offices. The relevant equipment families are grouped on the product side in the outdoor and street lighting range.

Lever

Status

What to check

CEE indoor lighting sheets BAR-EQ-110, BAT-EQ-127, IND-BA-116

Withdrawn

No incentive line to include in the financing plan

CEE outdoor lighting sheet RES-EC-104

Maintained

Version in force, technical conditions, timing of the application

Self-financing from the energy budget

Available

Consumption difference established by an audit

Financial lease or leasing

Available

Term, buyout value, accounting treatment

Energy performance contract

Available

Baseline, measurement and verification plan

Checking actual eligibility before building a financing plan

A sheet still in the catalogue does not mean automatic eligibility. Three checks determine the application, and they are made before the quote is signed, never after.

  • The applicable version. Sheets are revised by order. The technical criteria to be met are those of the version in force on the date the operation is committed.
  • Timing. The incentive role of the scheme requires the commitment with the obligated party to be formalised before the works start. An order placed beforehand closes the file.
  • The technical scope. Each sheet describes precisely the equipment covered and the characteristics required. A luminaire outside the scope generates no eligible volume.

Until these three points are in writing, no amount should appear in a financing table. An incentive that is expected but not obtained turns into a budget overrun at a point when the project is already committed.

Self-financing and trade-offs on the energy budget

The simplest form of financing remains the internal trade-off between a recurring operating expense and a one-off capital expense. Lighting consumption is already in the budget, diluted in the site's overall bill. An audit makes it possible to isolate it and turn it into an identified resource.

The approach requires a solid basis: inventory of the installed base, actual power ratings, operating hours that are recorded rather than estimated. This is exactly what an on-site lighting audit produces, with measurements and a survey of the existing installation. Without this basis, the trade-off rests on orders of magnitude that a finance department will refuse to accept.

Financial leasing and energy performance contracts

A financial lease or leasing spreads the expense over periodic payments, without drawing on the investment budget for the year. Lighting equipment lends itself well to this arrangement: it is identifiable, capitalised and has a long service life. The points to negotiate are the term, the buyout value at the end of the contract and how maintenance is handled.

An energy performance contract goes further, since the provider commits to a level of consumption after the works. This arrangement only makes sense if the baseline is established beyond dispute and if a measurement and verification plan is appended to the contract. For a lighting package alone, the complexity of the scheme is mainly justified for large or multi-site installations.

Depreciation of lighting equipment

The accounting question arises as soon as the amount exceeds the capitalisation threshold used by the company. A one-off replacement of light sources is expensed, a full renovation of a hall is capitalised and depreciated. The period used must match the actual service life of the equipment, not a habit inherited from older technologies.

This decision is prepared with the finance department before the file is submitted, because it changes the annual charge shown and therefore how the project is read. The service life and operating cost data to be provided are those we detail in our analysis of the real cost of LED lighting over ten years.

Building the case without relying on an incentive

A defensible case comes down to four documents. A survey of the existing installation with power ratings and operating hours. A photometric study that sets the number of luminaires needed to achieve the required levels. A complete costing including removal, access equipment and rework of the circuits. A scenario table comparing keeping things as they are with renovation over the operating life.

This structure has a direct advantage: it does not collapse if a support scheme disappears along the way. Any incentive on an outdoor package then improves a plan that is already balanced, instead of being its cornerstone. For these outdoor phases, equipment is chosen from the outdoor lighting families according to the nature of the areas to be treated.

Send us your plans and energy bills via our contact page to obtain the audit and costed study that will form the basis of your financing plan.

Further reading: Lighting budget: costing your renovation for the next financial year and Industrial lighting renovation: where to start. Reference: catalogue of standardised CEE operation sheets.

On the equipment side, at Rexylum: the High bays range and the Safety and control range.

Frequently asked questions

Which CEE bonuses remain to finance a lighting renovation?
The order of 23 February 2026 removed from the catalogue the sheets BAR-EQ-110, BAT-EQ-127 and IND-BA-116, which covered the replacement of indoor luminaires. Sheet RES-EC-104, covering the renovation of outdoor lighting installations, is still in the catalogue. The specific operations route remains, but it is out of reach for most lighting renovation projects.
How can a lighting renovation be financed without a bonus?
Several levers remain available: self-financing from the energy budget line, based on a consumption gap established by an audit, financial leasing or lease-purchase, which spread the expense over periodic rents, and the energy performance contract, in which the provider commits to a consumption level after the works. The latter is mainly justified for large or multi-site installations.
How is a lighting renovation depreciated in the accounts?
The question arises as soon as the amount exceeds the capitalisation threshold used by the company. A one-off replacement of sources is expensed, whereas a complete renovation of a hall is capitalised and depreciated. The period adopted must match the actual service life of the equipment, and the decision is prepared with the finance department before the file is submitted.

Related articles

More articles, those in the same category first.

View all articles
  • Manufacturing hall lit by suspended LED high baysAudit, renovation and profitability

    Relamping or full renovation: how to decide

    Layout, condition of the luminaires, warranties, compliance: the criteria for choosing between relamping and a full lighting renovation.

    Luminance ConsultingProfessional lighting design office

    5 min read

  • Industrial hall with a conveyor, lit by LED luminairesAudit, renovation and profitability

    Lighting budget: costing your renovation for the next financial year

    Lighting renovation cost explained: removal, access equipment, circuit rework and coordination, the items to budget so your LED project holds to the end.

    Luminance ConsultingProfessional lighting design office

    5 min read

  • Workshop workstations lit by LED luminairesAudit, renovation and profitability

    Measuring illuminance with a lux meter: method and pitfalls

    How a lux meter works, where to place the sensor, when to measure and how many points to take: the method for an illuminance reading that stands up.

    Luminance ConsultingProfessional lighting design office

    5 min read